Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Lawrence Homeowners
A snapped spring stops your day. One moment the door lifts like it always has, and the next there’s a loud bang from the ceiling of the garage and the door won’t budge more than a few inches. Old triple-deckers around the Stadium District and the tighter lots off Broadway run doors that work harder than most, and springs carry every bit of that weight. Our technicians have up to 15 years of experience replacing torsion and extension springs on the door you already own, and we handle same-day calls across Lawrence when the door has quit. Call (877) 492-1952 and we’ll get a trained tech out to look at it and quote the job before anything starts.
What Our Garage Door Spring Repair Service Includes
Springs are the most common failure on a garage door, and they’re also the part that scares people most. That’s reasonable. A wound torsion spring stores enough force to do serious damage, and the tension, not just the weight of the door, is what makes it dangerous. We treat every spring job as a safety-critical repair, not a quick swap. Here’s what each piece of our spring work covers.
Torsion Spring Replacement
Torsion springs mount on the shaft above the door and wind up tight to counterbalance it. When one breaks, you’ll usually hear a clang and the door may lift a few inches and stop, or stay stuck against the floor. We replace the failed spring (and often the matched pair, since one usually fails shortly after the other), reset the balance, and check the cable drums and center bearing while we’re up there.

Extension Spring Replacement
Extension springs run along the sides of the door on older sections and stretch as the door closes. They need safety cables run through them so a break doesn’t send the spring flying, and worn springs sag out of line long before they snap. We replace extension springs in matched pairs, install fresh safety cables, and rebalance the door so it lifts smoothly without the opener straining.

Broken Spring Repair
A broken spring can be a clean break at the coil or a crack you can’t see until you look closely. If the door lifts unevenly, hangs on one side, or the opener groans but the door barely moves, the spring is a likely cause. We diagnose the exact failure before quoting, so you’re not paying for a spring replacement when the real problem is a worn cable or a bent track.

Spring Adjustment
Sometimes the spring is intact but out of adjustment – the door feels heavy, drifts down on its own, or the opener has to fight it open. An out-of-balance door wears out the opener faster and puts stress on the panels and hinges. We test the balance, adjust the tension to spec, and confirm the door holds its position when stopped halfway up.
Safety Cable Installation
Safety cables are the thin steel cables that run through the center of extension springs so a broken spring stays contained. Many older doors around Lawrence were installed without them, or the originals have rusted through. We install new cables rated for the door’s weight and secure them to the track and header so the spring can’t fly loose.
Spring Inspection
Springs don’t always give clear warning. A full inspection looks at the coils for hairline cracks, the torsion tube for wear, the anchor plates for looseness, and the door’s balance and travel. If you’ve noticed a strange noise or the door just feels different, an inspection tells you whether you’re looking at a repair now or a problem down the road.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on the door you have, not just one brand. Our technicians are trained on eight major manufacturers – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor – which means we know how each one is built and where its springs tend to wear. LiftMaster and Chamberlain systems often show up with openers that push harder than the spring allows, and knowing that pattern helps us spot spring trouble the door’s own hardware would otherwise hide. Clopay and Amarr doors use torsion setups with specific coil counts and wire gauges; matching the spring to the door’s weight is what keeps the door balanced instead of working against itself. Wayne Dalton and Craftsman doors turn up often on older Lawrence properties, and their extension spring setups behave differently enough that we size the replacement by door weight rather than guesswork. Raynor equipment has its own spring geometry too, and we’re used to working with it.
Servicing competing brands means we recommend what your door needs, not what one manufacturer wants to sell. Whether you have Clopay, Amarr, Wayne Dalton, Craftsman, or any other make, we can help and we’ll tell you what the actual failure is.
Signs You Need Garage Door Spring Repair Right Now
Springs fail in a handful of recognizable ways. If any of these sound familiar, don’t keep operating the door – it puts more strain on the opener and the cables with every cycle.
- A loud bang from the garage. That clang is often a torsion spring letting go all at once. The door may still lift a few inches before it binds, and running the opener after that can burn out the motor.
- The door feels dead heavy when you lift it by hand. A balanced door should open with one hand and stay put halfway up. If it drops or won’t budge, the spring isn’t carrying its share of the weight.
- The door opens crooked or hangs on one side. Uneven lift usually means one spring in a pair has failed and the other is doing all the work. Left alone, that surviving spring wears out fast too.
- The opener strains, grinds, or quits mid-travel. When the spring stops helping, the opener takes the load it wasn’t built for. Fixing the spring early protects the opener motor and saves a second repair.
- Visible gaps or cracks in the coil. A torsion spring with a clear gap or an extension spring that’s stretched longer than its neighbors is close to failing. Catching it during an inspection is far cheaper than catching it after it snaps.
Our Garage Door Spring Repair Process – Step by Step
- 1
We listen to what the door is doing. You describe the bang, the crooked lift, the door that won’t come down. We ask a couple of quick questions to figure out whether it’s torsion or extension, and whether the opener or cables might be involved too.
- 2
We diagnose on site. A technician checks the spring coils for breaks and cracks, tests the door’s balance by hand, and looks at the cables, drums, and hinges. We don’t guess which part broke; we confirm it.
- 3
We quote before we touch anything. You get a written estimate for the repair, with the price agreed before any work begins. If a second spring or a cable needs attention, you’ll know that upfront – no surprise invoice later.
- 4
We do the repair with the right safety gear. Torsion springs are unwound and replaced with proper winding bars, extension springs come out with their cables contained, and everything gets torqued back to the door’s weight. The new spring gets a balance check before we finish.
- 5
We test the door end to end. The door cycles several times, we confirm it stays put halfway up, and we check that the opener isn’t straining. Then we walk you through what failed and what we changed so you know what to watch for.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Lawrence?
A typical garage door spring repair in Lawrence runs $180 – $340 for one spring, depending on the door’s size, the spring type, and how much labor the job takes. A matched pair is usually replaced together, so a pair costs about twice that range. Other common jobs on a spring-related visit estimate as follows:
| Service | Typical Estimated Range |
|---|---|
| Spring Repair (one spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
| Opener Repair | $120 – $320 |
| Garage Door Repair (general) | $150 – $600 |
What moves the price: the number of springs, the door’s weight and height (each door’s spring is sized to balance it), and whether cables or drums were damaged when the spring let go. Older doors sometimes need a spring engineered to their weight rather than a standard size. To avoid overpaying, get a written estimate that names the parts and confirms whether one or both springs are being replaced.
Our free estimate includes the on-site diagnosis, a clear explanation of what failed, and the price agreed before work starts – the written estimate sets the final price. If the quote changes, it’s because we found something a visual check couldn’t reveal, and we’ll tell you before doing anything.
Garage Door Spring Repair Near Lawrence – Our Service Area
We handle spring repair across Lawrence and into nearby Methuen, Andover, North Andover, Haverhill, Dracut, Tewksbury, and the smaller towns around the Merrimack Valley. Response times vary by day and how far out you are, but we book same-day when the schedule allows for emergency calls. If you’re in one of the neighboring towns, our garage door spring repair team covers that area too, and we can give you an honest arrival window when you call.
Serving Lawrence, MA – Our Local Coverage Area
We serve Lawrence and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Lawrence
Garage door spring repair is the replacement, adjustment, or rebalancing of the springs that lift the weight of the door so the opener and your own hands don’t have to. Torsion springs (on a shaft above the door) or extension springs (running along the sides) do most of the lifting work, and when one fails the door gets dangerously heavy. We replace, adjust, and inspect both types, matching the spring to the door’s weight.
Most spring replacements take about an hour to two hours on site, including the balance check and testing. A single torsion spring on a standard door is on the shorter end; a matched pair, an extension spring setup, or a job that includes new cables takes a bit longer. We give you a realistic window when you call rather than a guess.
Spring repair in Lawrence typically runs $180 – $340 for one spring, and a matched pair usually lands near twice that since the pair is replaced together. The exact price depends on the spring type, door weight, and whether cables or hardware were damaged. Call (877) 492-1952 for an exact quote – estimates are free and agreed before work starts.
Yes, we service Clopay, Amarr, Wayne Dalton, Craftsman, and the other major brands we’re trained on, along with most other makes. Knowing each brand’s spring geometry and typical failure points helps us size the replacement correctly instead of guessing. If you’re unsure what brand your door is, we can usually identify it from the hardware and the door itself.
Same-day spring repair is available across Lawrence when the schedule allows, and a door that won’t open after a loud bang is exactly the kind of call we prioritize. We built our emergency service for the moments when waiting until Monday isn’t an option. Call early if you can and we’ll get you the soonest opening.
Yes – our spring work is covered by a satisfaction guarantee. If something we replaced or adjusted isn’t right after the job, call us and we’ll make it right. We walk you through what’s covered before we finish so there’s no confusion later.
Clear the area directly under and around the door, move vehicles out of the garage if the door won’t open, and stop running the opener once the spring has failed. Running a door with a broken spring can damage the opener motor and the door itself. Beyond that, there’s nothing you need to do – just have a rough idea of when the door started acting up.
Schedule Your Garage Door Spring Repair Service in Lawrence Today
A broken spring gets worse the longer the door keeps running. We’ll diagnose the actual failure, quote you a clear price before any work, and put a trained technician on it with same-day availability when the schedule allows. Whether it’s a garage door spring repair on a single door or a matched pair, one call covers it. Call (877) 492-1952 for a free, no-obligation estimate. You can also read more about our full-service Lawrence Garage Door Repair Co capabilities.
Written by the team at Lawrence Garage Door Repair Co.